National Electric Code

You are here

Solar365

692-Fuel Cell Systems

I. General

692.3 Other Articles. Wherever the requirements of other articles of this Code and Article 692 differ, the requirements of Article 692 shall apply, and, if the system is operated in parallel with a primary source(s) of electricity, the requirements in 705.14, 705.16,
705.32, and 705.143 shall apply.

692.4 Installation.

(A) Fuel Cell System. A fuel cell system shall be permit-

695-Fire Pumps

695.1 Scope.

(A) Individual Sources. Where reliable, and where ca pable of carrying indefinitely the sum of the locked- rotor current of the fire pump motor(s) and the pressure maintenance pump motor(s) and the full-load current of the associated fire pump accessory equipment when connected to this power supply, the power source for an electric motor driven fire pump shall be one or more of the following.

700-Emergency Systems

I. General

700.4 Tests and Maintenance.

(A) Conduct or Witness Test. The authority having juris- diction shall conduct or witness a test of the complete system upon installation and periodically afterward.

(B) Tested Periodically. Systems shall be tested periodically on a schedule acceptable to the authority

701-Legally Required Standby Systems

I. General

701.1 Scope. The provisions of this article apply to the electrical safety of the installation, operation, and maintenance of legally required standby systems consisting of circuits and equipment intended to supply, distribute, and control electricity to required facilities for illumination or power, or both, when the normal electrical supply or system is interrupted.

The systems covered by this article consist only of those that are permanently installed in their entirety, including the power source.

702-Optional Standby Systems

I. General

702.1 Scope. The provisions of this article apply to the installation and operation of optional standby systems.

The systems covered by this article consist of those that are permanently installed in their entirety, including prime movers, and those that are arranged for a connection to a premises wiring system from a portable alternate power supply.

705-Interconnected Electric Power Production Sources

I. General

705.4 Equipment Approval. All equipment shall be ap- proved for the intended use. Utility-interactive inverters for interconnection systems shall be listed and identified for interconnection service.

705.10 Directory. A permanent plaque or directory, denoting all electric power sources on or in the premises, shall be installed at each service equipment location and at locations of all electric power production sources capable of being interconnected.

708-Critical Operations Power Systems

FPN: Rules that are followed by a reference in brackets contain text that has been extracted from NFPA 1600-
2007, Standard on Disaster/Emergency Management

and Business Continuity Programs. Only editorial

changes were made to the extracted text to make it
consistent with this Code.

725-Class 1, Class 2, and Class 3

I. General

725.3 Other Articles. Circuits and equipment shall com- ply with the articles or sections listed in 725.3(A) through (G). Only those sections of Article 300 referenced in this article shall apply to Class 1, Class 2, and Class 3 circuits.

(A) Number and Size of Conductors in Raceway. Sec- tion 300.17.

727-Instrumentation Tray Cable- Type ITC

727.1 Scope. This article covers the use, installation, and construction specifications of instrumentation tray cable for application to instrumentation and control circuits operating at 150 volts or less and 5 amperes or less.

727.2 Definition.

Pages

Subscribe to National Electric Code