I. General
530.1 Scope. The requirements of this article shall apply to television studios and motion picture studios using either film or electronic cameras, except as provided in
520.1, and exchanges, factories, laboratories, stages, or a portion of the building in which film or tape more than
22 mm ( 7/g in.) in width is exposed, developed, printed,
cut, edited, rewound, repaired, or stored.
FPN: For methods of protecting against cellulose nitrate film hazards, see NFPA 40-2007, Standard for the Storage and Handling of Cellulose Nitrate Film.
530.2 Definitions.
Alternating-Current Power Distribution Box (Alter- nating-Current Plugging Box, Scatter Box). An ac distri- bution center or box that contains one or more grounding-type polarized receptacles that may contain overcurrent protective devices.
Bull Switch. An externally operated wall-mounted safety switch that may or may not contain overcurrent protection and is designed for the connection of portable cables and cords.
Location (Shooting Location). A place outside a motion picture studio where a production or part of it is filmed or recorded.
Location Board (Deuce Board). Portable equipment containing a lighting contactor or contactors and overcurrent protection designed for remote control of stage lighting.
Motion Picture Studio (Lot). A building or group of buildings and other structures designed, constructed, or permanently altered for use by the entertainment industry for the purpose of motion picture or television production.
Plugging Box. A dc device consisting of one or more 2- pole, 2-wire, nonpolarized, nongrounding-type recep- tacles intended to be used on dc circuits only.
Portable Equipment. Equipment intended to be moved from one place to another.
Single-Pole Separable Connector. A device that is in- stalled at the ends of portable, flexible, single-
conductor cable that is used to establish connection or disconnection between two cables or one cable and a single-pole, panel-mounted separable connector.